Create beautiful, vibrant custom apparel with our DTF heat transfers! Our transfers are suitable for compatible cotton, polyester, and cotton/polyester blend fabrics.
🔥 Heat Press Settings
- Temperature: 302°F (150°C)
- Press Time: 10–12 seconds
- Pressure: 3–4 kg (supplier recommendation)
- Peel Type: HOT PEEL
- Second Press: Recommended for enhanced durability
✨ Application Instructions
Step 1: Prepare Your Garment
Ensure your T-shirt, hoodie, sweatshirt, or tote bag is clean and dry. Pre-press briefly to remove wrinkles and moisture.
Step 2: Position Your Transfer
Place the DTF transfer on the garment with the design facing upward and adhesive side against the fabric.
Step 3: Heat Press
Preheat your heat press to 302°F (150°C).
Press for 10–12 seconds using the supplier-recommended pressure.
Step 4: Hot Peel
While the design is still hot, carefully remove the transparent carrier film.
Do not wait for the transfer to cool completely before peeling.
Step 5: Second Press
After the design has cooled, cover it with parchment paper or a suitable protective sheet.
Perform a short finishing press according to the transfer supplier’s recommendations to help improve adhesion and durability.
Step 6: Enjoy Your Creation!
Your customized garment is ready!
🛠️ Troubleshooting Common DTF Problems
Problem: Transfer Won’t Stick
Possible causes:
- Insufficient heat or pressure
- Moisture in the fabric
- Uneven heat distribution
Solution: Verify that your heat press reaches 302°F and delivers even pressure. Pre-press the garment to remove moisture.
Problem: Design Lifts During Peeling
Possible causes:
- Film was not peeled while hot
- Insufficient pressure
- Incomplete adhesive bonding
Solution: Lay the carrier film back down, repress as appropriate, and carefully peel while hot.
Problem: Transfer Peels After Washing
Possible causes:
- Inadequate initial pressing
- Washing too soon
- Excessive dryer heat
Solution: Follow the pressing instructions, perform the recommended finishing press, and wait at least 24 hours before washing unless otherwise specified by the supplier.
Problem: Design Cracks or Fades
Possible causes:
- Excessive heat
- Improper washing
- Incomplete adhesive bonding
Solution: Wash inside out using cold water, avoid bleach, and air dry whenever possible.
Problem: Design Has Bubbles or Wrinkles
Possible causes:
- Moisture in the garment
- Uneven pressure
- Wrinkled fabric
Solution: Pre-press the garment, smooth the fabric, and ensure the transfer lies flat before pressing.
Problem: Polyester Fabric Discolors
Possible causes:
- Heat sensitivity
- Dye migration
- Excessive pressing
Solution: Test the garment before production. Some polyester garments may require specialty low-temperature transfers.
🧼 Washing & Care Instructions
- Wait at least 24 hours before washing.
- Turn garments inside out.
- Wash in cold water.
- Use mild detergent.
- Avoid bleach.
- Hang dry when possible.
- Do not iron directly over the design.
- Avoid excessive heat when drying.
⚠️ Important Information
These pressing settings are based on our transfer supplier’s recommendations. Results may vary depending on garment material, heat press equipment, and application technique.
The specified 3–4 kg pressure should be verified against your equipment’s pressure measurement system.
C2Z Pressed Inc. is not responsible for damage caused by incorrect application, improper pressing, or failure to follow care instructions.
💌 Need Assistance?
Email: [email protected]
TikTok: @c2zpressedinc
Customer Service Hours: Monday–Friday, 9 AM–7 PM Central Time
We strive to respond within 24–48 business hours.
🧡💚 C2Z Pressed Inc.
Where Creativity Comes to Life!
Craft It. Press It. Love It! ✨